Water heater problems are normally self-evident,either the water does not become hot or it starts to leak or makes strange gurgling noise. These problems are commonly found in every household. But most revolve around the same symptoms and can be handled or repaired by you. Knowing the basic water heater repairs can help you a lot in your day to day life. It is quite an easy way to resolve these issues.
-
There are a variety of problems which can be faced while using a water heater for a long duration. If your heater is not providing you with sufficient hot water supply,then the first thought that come in mind is whether the heater is getting the required power to heat the water. Sometimes there might be a scenario where the exhaust valve gets jammed,the valve opens when the temperature in the tank is higher than its limit and hence releases the pressure within. If the valve is clogged for a long time there is a risk of the heater exploding. Valves can be easily cleaned,and you don’t need a plumber for that. If you check the valve in regular intervals of time,it will help the water heater to become durable and safer. If you are at all suspicious about the mechanism of valves,getting it replaced as soon as possible is the best option.
Sometimes a situation is seen where steam or boiling water comes from the valve,or we hear rumbling sounds. In such cases,shutting the heater off at once is the best solution to avoid any kind of problems. Water leakage is also a reason of improper functioning of water heater,hence keeping a timely check on the leakage can also help to maintain its proper operation. Sometimes in the long run sediments get accumulated inside the heater unit because of regular use of the heating mechanism. Thus clearing out the water or flushing can help. These minor repairs make the heater quite durable and also controls the damage which can be caused due to negligence.
-
The second most encountered problem in water heaters is the anode rod. It is the device that protects the inside of the heater by following the process of electrolysis. This is an important process which helps the unit to become long lasting. Because if the decomposition of the rod stops it causes the decomposition of the interior lining. So if the rod is dissolved to an extent where it does not perform the task properly,it has to be replaced. If you are familiar with replacement then it can be done at home otherwise it is suggested that an electrician or a professional is called to do the replacement work. Knowing the basic water heater repairs might prove useful.
-
There are also instances when we monitor that the heater starts taking a longer time to provide hot water. It is primarily because of the build up of lime elements. If you are supplied with hard water,this can be the reason of delay. We can either use water softener or clean the heating parts regularly to avoid such problem. Cleaning can be done by disassembling the heating parts,soaking them in vinegar and then removing or scratching the accumulation.
Most electric heaters use 220-240 volts. Inside the water heater’s power enters the thermostat through the top two terminals. To verify the proper stats we can turn the power on and check the voltage,it should have a reading between 220-240 volts. If the power supply is fine then a check should be performed on the other parts of the gadget. Sometimes,due to burnt wires the electric current does not reach the thermostat. In that scenario wires have to be changed. A water heater can be highly durable if basic water heater repairs are taken cared of from time to time.